Sending Cutting Data - Roland EGX-300 User Manual

Part 1
7
Make sure the blinking cursor is on "Y" and press the
[ENTER] key.

1-12 Sending Cutting Data

NOTICE
Do not operate beyond capacity or subject the tool to undue force.
The tool may break. If machining operation beyond capacity is started inadvertently, immediately press the
EMERGENCY STOP switch.
If the cover must be opened during cutting, first press the [ENTER/PAUSE] key to pause the EGX-300, then
open the cover. After the cover has been closed, cutting resumes when the paused state is canceled.
(The spindle will not rotate while the cover is open.)
The EGX-300 performs cutting after receiving cutting data from the computer (application).
Data may be output, for example, after it has been created using any of a number of applications, or from driver.
In this section, general matters related to data output are explained. Refer to this section when carrying out data output. For details of the
cutting data output method, refer to the operation manual for the application software or driver used.
Setting the Output device
Please select from among the models shown below when making the settings for output device with the application software.
Output
model
EGX-300
PNC-2300A
CAMM-2 Series
CAMM-3 Series
* When set to "AUTO," the machine automatically determines whether the mode 1 or mode 2 instruction system is used.
32
Instruction
system
CAMM-GL I
CAMM-GL I
CAMM-GL II
CAMM-GL I
8
Selecting "Y" displays the following message.
Selecting "N" returns to the coordinate display (the
screen shown in step 1).
Make sure that "< >" appears.
Command setting
on the EGX-300
AUTO
AUTO
AUTO
AUTO
Coordinate unit setting
on the EGX-300
0.01 mm
0.01 mm
0.01 mm
0.01 mm