Setting The Connection Parameters - Roland EGX-300 User Manual

1-5 Setting the Connection Parameters

Connection with a parallel cable is called a "parallel connection," and connection with a serial cable is called a "serial connection." Make
the appropriate settings on both the computer and the EGX-300 to configure the equipment for the type of connection that has been
made. Normally, the setting on the EGX-300 should be made to match the setting on the computer. The steps below describe how to set
connection parameters on the EGX-300. To make the settings on the computer, refer to the manual for the computer or the software in
use.
1 Press the [MENU] key to make the following screen
appear on the display.
3
Press the [ ] key to move the blinking cursor (" ") to
"AUTO," and then press the [ENTER] key.
5
Press the [MENU] key once.
Press the Make the settings for data bits, then press
the [ENTER] key.
For serial connection only
7
Press the [MENU] key once.
Make the settings for baud rate, then press the
[ENTER] key.
For serial connection only
2
Press the [ ] key to move the blinking cursor (" ") to
"I/O," and then press the [ENTER] key.
4
Press the [MENU] key once.
Make the settings for stop bit, then press the [EN-
TER] key.
For serial connection only
6
Press the [MENU] key once.
Make the settings for parity check, then press the
[ENTER] key.
For serial connection only
8
Press the [MENU] key once.
Make the settings for handshake, then press the
[ENTER] key.
For serial connection only
Part 1
19