Roland EGX-300 User Manual page 39

Performing Repeat Cutting
The data buffer is the place where data received from the computer is stored temporarily. (The data in the data buffer can be erased by
switching off the power or executing the "CLEAR".)
Executing the "REPEAT" calls up the cutting data stored in the EGX-300's data buffer and executes the replotting procedure.
When replotting is executed, the entire data content of the data buffer is called up. When you perform replotting, clear the data from the
data buffer before sending the cutting for replotting from the computer.
1 Press the [MENU] key to make the following screen
appear on the display.
3
Install the cutter and load the material.
After closing the cover, use the software to send
cutting data.
5
Press the [MENU] key to make the following screen
appear on the display.
2
Press the [ ] key to move the blinking cursor (" ") to
"CLEAR," then hold down the [ENTER] key for 0.5
sec or more. This makes "CLEAR" start to flash.
4
After cutting has finished, remove the cut material
and load a new piece. Set the origin point if neces-
sary.
6
Press the [ ] key to move the blinking cursor (" ") to
"REPEAT," and then press the [ENTER] key.
Part 2
37