Roland EGX-300 User Manual page 19

4 The Setup program starts. Follow the messages to carry
out setup and finish setting up the program.
5
If the following screen appears while installing the
driver, click the drop-down arrow and choose the port
for the cable connected to the computer.
When using an RS-232C (serial) cable
[COM1:] or [COM2:]
When using a printer (parallel) cable
[LPT1:] or [LPT2:]
7
When all installation finishes, the screen show below
appears.
Click [Close].
9
Remove the CD-ROM from the CD-ROM drive.
* When the setup for one program finishes, the
setup for the next program starts.
In the interval until the next setup starts, a dialog
box showing the progress of processing is
displayed.
6
The driver settings appear.
When you make the settings for the communication
parameters of EGX-300, make the parameters match the
values displayed here.
Click [Close] to finish installing the driver.
8
After returning to the menu screen for installation, click
.
Part 1
17