Loading A Cutter - Roland EGX-300 User Manual

Loading Workpiece Using Commercially Double-sided Tape
Apply the double-sided tape to the bottom of the workpiece and secure it to the table.
Double-sided
tape

1-7 Loading a Cutter

Installing the Cutter holder and Collet
NOTICE
To install an end mill using the optionally available collet set (ZC-23), detach the blade holder. If you try to
perform machining with the blade holder installed, the vibration may make it come loose and fall off.
Be sure to use the wrench included with the unit. Using a wrench other than the included one may result in
overtightening, making it impossible to remove the collet or damaging the spindle.
Install a blade holder and collet that match the tool used.
When passing the tool through the holes in the cutter holder and
collet, the combination is suitable if it fits perfectly into the
hole.
Workpiece
Install the cutter holder and collet for the cutter to be used.
Head
Wrench
(21 mm end of
the wrench)
Collet
Part 1
Cutter holder
Wrench
(10 mm end of the wrench)
21