Roland EGX-300 User Manual page 41

Canceling the Paused State to Resume Cutting
After changing the feed rate, cancel the paused state. Cutting then resumes at the new feed rate or spindle speed.
1
Press the [MENU] key to make the following screen
appear on the display.
Stopping the Cutting Process
In the case that you begin cutting and then find that you have sent the wrong cutting data, perform the following operation.
1 Press the [ENTER/PAUSE] key while cutting is in
progress. One cutting step is performed, after which
operation stops. The display changes to show the
following message.
3
Press the [ ] key to move the blinking cursor (" ") to
"STOP," and then press the [ENTER] key.
2
Press the [ ] key to move the blinking cursor (" ") to
"CONTINUE," and then press the [ENTER] key.
2 Use the software to stop data output.
Part 2
39