Adding Phones to the Cisco Unified CallManager Database
Adding Phones with Auto-Registration
Note
Cisco Unified SIP Phone 3951 Administration Guide for Cisco Unified CallManager 5.1
2-10
Chapter 2
Table 2-4
Methods for Adding Phones to the Cisco Unified CallManager
Database
Requires MAC
Method
Address?
Auto-registration
No
Using the
Yes
Cisco Unified
CallManager Ad-
ministration
Using BAT
Yes
By enabling auto-registration before you begin installing phones, you can:
Automatically add a Cisco Unified IP Phone to the Cisco Unified
•
CallManager database when you physically connect the phone to your IP
telephony network. During auto-registration, Cisco Unified CallManager
assigns the next available sequential directory number to the phone.
•
Add phones without first gathering MAC addresses from the phones.
Quickly enter phones into the Cisco Unified CallManager database and
•
modify any settings, such as the directory numbers, from
Cisco Unified CallManager.
•
Move auto-registered phones to new locations and assign them to different
device pools without affecting their directory numbers.
You should use auto-registration to add less than 100 phones to your network. To
add more than 100 phones to your network, use the Cisco Unified CallManager
Bulk Administration (BAT). See the
page
2-11.
Preparing to Install the Cisco Unified IP Phone on Your Network
Notes
Results in automatic assignment of
directory numbers
Requires phones to be added individ-
ually
Allows for simultaneous registration
of multiple phones
"Adding Phones with BAT" section on
OL-10969-01