Verifying The Phone Startup Process - Cisco 3951 Administration Manual

Verifying the Phone Startup Process

Step 3
Step 4
Verifying the Phone Startup Process
Cisco Unified SIP Phone 3951 Administration Guide for Cisco Unified CallManager 5.1
3-10
Place the handset on the ear-piece rest.
d.
Insert two screws into a wall stud, matching them to the two screw holes on the
back of the footstand.
The keyholes fit standard phone jack mounts.
Hang the phone on the wall.
After the Cisco Unified IP Phone has power connected to it, the phone begins its
startup process by cycling through these following steps:
These buttons lights up:
1.
Voice Message Light Indicator
–
Line 1 Light Indicator
–
Line 2 Light Indicator
–
Conference button
–
MWI button
–
Speaker button
–
Mute button
–
The LCD screen displays the Cisco Systems, Inc., logo screen.
2.
The LCD screen displays a series of messages that inform you of various
3.
activities that the phone performs as it starts up. If the phone upgrades its
firmware as part of the startup process, additional messages will inform you
about this process.
The main LCD screen displays this information:
4.
Current date and time
–
Primary directory number
–
If the phone successfully passes through these stages, it has started up properly.
If the phone does not start up properly, see the
section on page 7-1.
Chapter 3 Setting Up the Cisco Unified IP Phone
"Resolving Startup Problems"
OL-10969-01