Using the Voodu Valve with a Rocktron All Access
A Rocktron All Access
direct access to specific Voodu Valve features and parameters from the footswitch at any time.
To use an All Access
Step 1
Access to the REMOTE jack of the Voodu Valve using a 7-pin MIDI cable, as shown below.
To set up the Voodu Valve for remote operation, do the following:
Reinitialize the controller assignments as shown earlier in this section under the heading
Step 2
"Restoring the Voodu Valve Controller Assignments". This will match up the Voodu Valve's
controller assignments to the All Access. A code of "221" must be entered to initialize only the
controller information.
™
MIDI footswitch can act as a dedicated remote control for the Voodu Valve—allowing
™
footswitch as a dedicated remote, connect the MIDI OUT of the All
™
in REMOTE mode