Thermal Transfer Model; Side Doors And Megatop; Integral Liner Takeup Unit; Media Supply Hub - Intermec EasyCoder F2 Installation & Operation Manual

Thermal Transfer
Model
Side Doors
Integral Liner
Takeup Unit

Media Supply Hub

3-inch Adapter

Intermec EasyCoder F2 – Installation & Operation IPL Version, Ed. 1
The thermal transfer mechanism is only available as a factory-
installed option. It allows the use of both direct thermal and thermal
transfer supplies.
The EasyCoder F2 comes with either a short side door, which
only covers the print mechanism or with a long side door, which
encloses the entire media compartment. The long side door has
a slot for external media supply. The long side door is generally
illustrated throughout this manual, but pictures of the short side
door can be found at the start of this chapter and in Chapter 4,
"Media Load."
The integral liner takeup unit is an optional device for peel-off
(self-strip) operation, which means that the labels are separated from
a liner (backing paper) after printing and the liner is wound up on an
internal hub. The unit also includes a guide shaft. Peel-off cannot be
combined with Quick-Load guides, see below.
The rotating media supply hub is designed to fi t media roll cores
with an internal diameter of 38-40 mm (1.5 inch). The hub can be
fi tted in the same positions as the supply roll post (see Chapter 2,
"Installation.") Being factory installed, the position of the hub is not
intended to be changed by the operator.
The 3-inch/76 mm adapter is with a rotating media supply hub
and makes it possible to use media rolls with 3 inch/76 mm inner
diameter cores. The adapter is pressed onto the media supply hub
and secured by a screw.
The 3-inch adapter is not used with a media roll supply post.
Chapter 8 Options
47