Maintenance And Troubleshooting - Healthrider HREL50020 User Manual

MAINTENANCE AND TROUBLESHOOTING

For smooth
operation of
the elliptical
crosstrainer,
the incline
ramp should be
kept clean.
Using a soft
cloth and mild
detergent,
clean dust and
other residue from the incline ramp where the wheels
make contact with it. Other parts of the elliptical
crosstrainer can also be cleaned in this manner.
Never use abrasives or solvents.
Inspect and tighten all parts of the elliptical crosstrainer
regularly. Replace any worn parts immediately.
CALIBRATING THE RESISTANCE AND INCLINE
SYSTEMS
If the elliptical crosstrainer's resistance or incline sys-
Incline
tem is not working properly, you may need to activate
Ramp
the calibration routine.
Wheel
To activate the resistance calibration routine, first
adjust the resistance to the lowest setting. Wait for the
resistance motor to stop. Next, press the RESIS-
TANCE + button. While the resistance motor is run-
ning, unplug the power cord from the wall. Wait for a
few seconds and then plug the power cord back in.
The resistance system will now calibrate itself. It will
not need to be calibrated again.
To activate the incline calibration routine, first
adjust the incline to the lowest setting. Wait for the
incline motor to stop. Next, press the RAMP + button.
While the incline motor is running, unplug the power
cord. Wait for a few seconds and then plug the power
cord back in. The incline system will now calibrate
itself. It will not need to be calibrated again.
19