No Mouse Pointer Displayed On The Screen; The Floppy Disk Cannot Be Read Or Written - Fujitsu ESPRIMO E3520 Operating Manual

Problem solutions and tips
Cause
Wrong monitor has been set under Windows 7
The wrong RAM modules have been inserted

No mouse pointer displayed on the screen

Cause
The mouse is not correctly connected.
The floppy disk cannot be read or written
Cause
The write protection of the floppy disk or the
floppy disk drive is activated.
The floppy disk drive controller is not enabled.
The floppy disk drive is not connected.
24
Remedy
► Restart the device.
► Press F8 while the system is booting.
Either the Windows Advanced Start Options menu
or the menu for selecting the operating system
appears.
► If the menu for selecting the operating
system appears, press
► Select Safe Mode or Safe Mode with Network.
► Select Start – Control Panel – Appearance and
Themes – Display to set the correct values for
the connected monitor, as explained in the
monitor instructions.
► See the technical manual for the mainboard
for information on which memory modules
can be used.
Remedy
► Shut down the operating system properly.
► Switch the device off.
► Check that the mouse cable is properly
connected to the system unit. If you use an
adapter or extension lead with the mouse
cable, check the connections.
► Make sure that only one mouse is
connected.
► Switch the device on.
Remedy
► Check whether the write protection of
the floppy disk or the floppy disk drive is
activated (refer to the "BIOS Setup" manual
and if necessary to the manual for the
mainboard).
► Check the relevant entries for floppy disk
drive in the Main menu of the BIOS Setup.
► Check that the floppy disk drive controller
is enabled (refer also to the manual for the
mainboard or in the "BIOS Setup" manual).
► Check that the cables of the floppy disk
drive are properly connected.
A26361-K1180-Z220-1-7619, edition 2
F8 .