No Mouse Pointer Displayed On The Screen; The Floppy Disk Cannot Be Read Or Written; Time And/Or Date Is Not Correct - Fujitsu ESPRIMO P372 Series Operating Manual

Troubleshooting and tips

No mouse pointer displayed on the screen

Cause
The mouse is not correctly connected.
The floppy disk cannot be read or written
Cause
The write protection of the floppy disk or the
floppy disk drive is activated.
The floppy disk drive controller is not enabled.
The floppy disk drive is not connected.

Time and/or date is not correct

Cause
Time and date are incorrect.
The lithium battery is discharged.
28
Remedy
► Shut down the operating system properly.
► Switch the device off.
► Check that the mouse cable is properly
connected to the system unit. If you use an
adapter or extension lead with the mouse
cable, check the connections.
► Make sure that only one mouse is
connected.
► Switch the device on.
Remedy
► Check whether the write protection of
the floppy disk or the floppy disk drive is
activated (refer to the "BIOS Setup" manual
and if necessary to the manual for the
mainboard).
► Check the relevant entries for floppy disk
drive in the Main menu of the BIOS Setup.
► Check that the floppy disk drive controller
is enabled (refer also to the manual for the
mainboard or in the "BIOS Setup" manual).
► Check that the cables of the floppy disk
drive are properly connected.
Remedy
► Set the correct time and date within the
operating system you are using.
or
► Set the correct time and/or date in the
BIOS Setup.
► If the time and date are repeatedly wrong
when you switch on your device, replace the
lithium battery (see
battery", Page 44).
"Replacing the lithium
Fujitsu Technology Solutions