Fujitsu ESPRIMO E3520 Operating Manual page 47

Installing an accessible 3
► Remove the cover (see chapter
► Remove the front panel (see chapter
► Remove the drive cover if one is fitted. To do this, press the corresponding drive cover
lightly out forwards and pull the drive cover forward out of the front panel.
► Remove the drive cage (see chapter
► Turn the drive cage over.
► Slide the drive into the casing (1). Make sure that the screw holes of the
drive cage and of the drive are aligned.
► Fasten the drive into place with the screws (2).
► Install the drive cage (see chapter
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Secure the front panel on the casing (see chapter
► Install the cover on the casing again (see chapter
It may be necessary to modify the entry for the drive in the BIOS Setup.
A26361-K1180-Z220-1-7619, edition 2
/ inch drive (e.g. diskette drive)
1
2
"Removing a cover", Page
"Removing the front panel", Page
"Removing the drive carrier", Page
2
"Installing the drive cage", Page
29).
2
2
1
34).
"Securing the front panel", Page
"Reattaching the cover.", Page
System expansions
30).
33).
31).
32).
39