Fujitsu ESPRIMO E3520 Operating Manual page 45

Installing an accessible 5
► Remove the cover (see chapter
► Remove the front panel (see chapter
► Remove the drive cover if one is fitted. To do this, press the corresponding drive cover
lightly out forwards and pull the drive cover forward out of the front panel.
Do not throw away the covers. If you remove the drive again, you must reinstall the
covers (cooling, fire protection or EMC regulations to be complied with).
EMC,electromagnetic compatibility
► Remove the drive cage (see chapter
► Turn the drive cage over.
► Take the new drive out of its packaging.
► Slide the new drive into the drive cage (1) until the stop. Make sure that the screw
holes of the drive cage and of the drive are aligned.
► Fasten the screws (2).
► Install the drive cage (see chapter
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Secure the front panel on the casing (see chapter
► Install the cover on the casing again (see chapter
It may be necessary to modify the entry for the drive in the BIOS Setup.
A26361-K1180-Z220-1-7619, edition 2
/ inch drive (e.g. DVD drive)
1
4
"Removing a cover", Page
"Removing the front panel", Page
"Removing the drive carrier", Page
2
2
2
"Installing the drive cage", Page
29).
1
"Securing the front panel", Page
"Reattaching the cover.", Page
System expansions
30).
33).
34).
31).
32).
37