Removing A System Fan - HP ProLiant DL145 Maintenance And Service Manual

Figure 61 System fans
If a system fan becomes defective, you must replace the fan to allow the server to operate properly.

Removing a system fan

1. Perform the pre-installation procedures described on page 11.
2. Disconnect the 14-pin power cable from the connector on the system board (P22).
3. Remove the power cable guide above the system fans:
a. Slide the power cable guide away from the power supply.
b. Pull the power cable guide toward the front of the server and place it out of the way.
Removal and replacement procedures 51