Drive bay configuration
The server supports three drive bays — two drive bays for hard disk drives and one drive bay for a 9.5-mm
optical drive.
Go to the HP website at http://www.hp.com/ and refer to the options list for this server model for the latest
information on supported hard drives and optical drives.
Figure 5 Drive bay configuration
Item
Description
1
Optical drive bay
2
Hard disk drive (HDD) bay 1
3
HDD bay 2
Cable routing diagrams
Figure 6 to Figure 8 show the cable routing for the optical drive as well as the SATA and SAS hard drives. For
detailed cable routing procedures for each type of drive, refer to the corresponding steps in the drive
configuration sections later in this chapter.
CAUTION: Route the drive cables neatly. If possible, follow the pre-installed cable bundles in the chassis. The
cables should be routed in a position where they will not be pinched or crimped by the top cover, and they
should not hamper proper airflow inside the chassis.
Removal and replacement procedures 14