HP ProLiant DL145 Maintenance And Service Manual page 21

Figure 14 Pre-installed screw locations in the non-hot-plug HDD carrier
Hard drives installed in the server are labeled as drive 1 and drive 2 from left to right when viewed from
the front of the server.
Figure 15 HDD bay locations
Removing a non-hot-plug SATA hard drive
If you intend to replace a non-hot-plug SATA hard drive with another non-hot-plug SATA hard drive, use the HDD
carrier and screws you remove from the old drive to install the new drive.
To remove a non-hot-plug SATA hard drive:
1. Perform the pre-installation procedures described on page 11.
2. Disconnect the data and power cables from the rear of the hard drive.
3. Remove the HDD carrier from the chassis:
a. Loosen the screw that secures the HDD carrier to the chassis.
b. Push the HDD carrier toward the front of the chassis, then slide it out completely.
Removal and replacement procedures 21