How To Silence An Alarm And Reset The System - Honeywell Accenta User Manual

Accenta/Optima User Guide
LED Keypad:
The LED should be on.
• Enter your code [0][1][2][3]. The exit beep starts.
• Press the key. The exit tone stops and the zone LED's 1to 3
come on.
• Select part-set program [2] or [3]. The system sets after a
short time. The LED goes out.
NOTE: There are no exit beeps if Silent Timed exit mode has been
programmed.

How to Silence an Alarm and Reset the System

If your system goes into alarm then be aware that intruders may be in
the premises. Seek assistance before investigating the cause of the
alarm.
LCD Keypad:
• Enter your code [0][1][2][3]. The alarm stops.
• The screen alternates, showing what caused the alarm and
prompting for user reset.
When two or more alarms have occured, the first alarm
has an F below the zone number, Tamper or PA.
Subsequent alarms will have a 1 indicating where the alarm has
taken place.
• Press . The system resets and displays the date and time if
there are no open Tampers, PA or Fire zones to cause a fault
lockout.
The system can be reset by the user only if the installer has
programmed it to do so. If the message Engineer Restore
Required appears on screen then the user must contact
the installer.
• After 30 seconds the system displays the date and time.
How to Silence an Alarm
Enter Your Code
12345678
00100000
User Restore
Press Reset
Resto red
by User
S u n d a y
5
1 2 3 4 5 6 7 8
Zones
[0][1][2][3] then
1 2 3 4 5 6 7 8
Zones
[2 or 3]
1 2 3 4 5 6 7 8
Zones
[0][1][2][3]
TP
0F
0 1 - J a n
14:10