Accenta/Optima User Guide
LED Keypad:
•
Enter your [4-digit code] to start the exit procedure (for more
information see How to Set the System).
•
Press
and the exit beep tone stops, and all
zones that can be omitted come on.
•
Press the zone [number] to be omitted. The LED now flashes to
show the zone as omitted. If a flat reject tone is heard, then the zone
cannot be omitted.
•
Press
or allow the system to set.
How to Quick Set the System
When you set the system you usually have about 30 seconds to exit the premises. This also means that you
need to wait 30 seconds for the system to set. You can reduce this time to just five seconds by carrying out a
Quick Set.
•
Enter your [4-digit code] to start the exit procedure. The exit beep tone starts.
(For more information see How to Set the System).
•
Press
to Quick Set the system and the exit beep tone changes to a more rapid tone.
The system sets in five seconds, and the exit tone stops.
Single Key Setting
If enabled by the engineer, the setting process can be started by pressing Set, rather than entering a user code.
How to Quick Set
LEDs for used
7
[4-digit code]
1 2 3 4 5 6 7 8
Zones
[Number]
1 2 3 4 5 6 7 8
Zones
1 2 3 4 5 6 7 8
Zones