Turning The System All On - Bosch Security Systems User Manual

Turning the System All On

Use this function to turn on the entire system. Once you press the [9] key,
exit delay time starts to count down. The length of exit delay time is
programmed by your security company. Check with them to learn how
much exit delay time your system allows. In this example, exit delay is 30
seconds. You should leave before exit delay time expires. Leaving after exit
delay expires causes an alarm event.
1. Make sure that all points are normal (not faulted).
2. Press the [9] key. If all points are normal, exit delay time begins.
You should leave now. If your system has a faulted point, you
should return the point to normal, or refer to Bypassing Points (on
page 16).
During exit delay, you may stop the system from turning on by
pressing [CLEAR]:
If you wish to, you can turn the system All On with No Delay by
pressing the [9] key again:
If you wish to, you may bypass points by pressing the [ ] key. The
system prompts you through the procedure:
3. When exit delay time expires, the keypad beeps three times and the
system turns on.
4. To turn the system off, enter your personal passcode.
30 SEC TO EXIT!
TO STOP
PRESS CLEAR
FOR NO DELAY
PRESS 9
TO BYPASS POINTS
PRESS
ALL ON
SYSTEM OK
13