Osburn 2200 Owner's Manual page 32

2. Put them on the horizontal air duct (C) (see figure 3.4b). Afterwards, push them towards the
bottom and sides so that they rest on the back of the firebox (D) and on the side air ducts. Install
the baffle support/extension (H) ensuring that it fits between the front risers and hold it in place.
Install the front secondary air tube as show in figure 3.4c ensuring air holes face forward. Install
the cotter pins as in fig 4.3. Installing the front secondary air tube (E) will stabilize baffle
assembly during the next step.
3. Install the middle and rear secondary air tubes ensuring air holes face forward. Install the cotter
pins as in fig 3.4.
Figure 4.4b
/32