Printronix

P9212 Maintenance Manual page 168

13. Remove the hammer bank (17): (See Figure 6–2.)
a. Note the U–shaped shims (18) installed at the end of the shuttle
b. Firmly gripping the right and left shuttle shroud screws (24) with
c. Be careful that the left linear bearing sleeve (23) does not slip off the
6–14
spring (22). Do not lose these shims while removing the hammer
bank.
your right and left thumbs, slowly lift the hammer bank while
keeping the shuttle shroud, hammer bank cables, and antirotation pad
in place.
shaft or that the hammer bank cables catch on any exposed edges of
the printer.
Replacement Procedures and Parts