Switching The Headset On/Off; Establishing A Wireless Link Between Headset And Base Station - Sennheiser DW Office Instruction Manual

4
3
4
3
³
»

Switching the headset on/off

If you place the headset into the base station, the headset automat-
ically switches to standby mode. In standby mode, the power
consumption is very low and the radiated power is reduced to a
minimum. The HEADSET LED
Switching the headset on
Press and hold the LINK button
The HEADSET LED
base station is established (where required). An ascending confirma-
tion beep is heard in the headset.
Switching the headset off
Press and hold the LINK button
The HEADSET LED
Establishing a wireless link between headset and
base station
To establish a wireless link between headset and base station:
Press the LINK button
The link is established. The LINK LED
HEADSET LED flashes blue.
To disconnect a wireless link between headset and base station:
Press the LINK button
The link is disconnected. The LINK LED
off.
You can also establish or disconnect the wireless link by pressing
the PC button
(depending on the selected mode
If your telephone has a built-in electronic hook switch supporting
the MSH standard (see page 13), you can only disconnect the wire-
¿
less link between headset and base station by placing the headset
into the base station. The control signals ("accept a call", "end a
call") of the headset are still transmitted to the electronic hook
switch without any restrictions.
Using the headset system
lights up blue during charging.
for 5 seconds.
flashes blue 3 times and the wireless link to the
for 5 seconds.
flashes red 3 times.
on the headset.
¿
lights up blue and the
on the headset.
¿
and the HEADSET LED
³
or the PHONE button
(PC or Phone), see page 28).
go
»
on the base station
23