Oven Light; Oven Door; Storage Drawer; Troubleshooting - Maytag SELF-CLEANING ELECTRIC RANGE Use & Care Manual

Oven Light

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.

Oven Door

For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door to the first stop position (opened about
4" [10.0 cm]).
2. Grasp door at each side. Do not use the door handle to lift
door.
3. Lift up evenly until door clears hinge arms.
To Replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is
completely seated on the hinges. Push down on the top
corners of the door to completely seat door on hinges. Door
should not appear crooked.

Storage Drawer

(on some models)
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull storage drawer out to the first stop position.
2. Lift up the front of the drawer and pull the drawer out to the
second stop position.
3. Grasp sides and lift drawer top up and out.
To Replace:
1. Fit the ends of the drawer glides into the rails in the range.
2. Lift up the front of the drawer and gently push in to the first
stop position.
3. Lift drawer up again and push until drawer is closed.

TROUBLESHOOTING

Try the solutions suggested here first in order to avoid the
cost of an unnecessary service call.
Nothing will operate
Has a household fuse blown, or has a circuit breaker
tripped? Replace the fuse or reset the circuit.
Cooktop will not operate
Is the control knob set correctly? Push in knob before
turning to a setting.
Excessive heat around cookware on cooktop
Is the cookware the proper size? Use cookware about the
same size as the surface cooking area, element or surface
burner. Cookware should not extend more than ½" (1.3 cm)
outside the cooking area.
Hot Surface indicator light stays on (on some models)
Does the Hot Surface indicator light stay on after control
knob(s) have been turn off? See "Cooktop Controls"
section.
Cooktop cooking results not what expected
Is the proper cookware being used? See "Cookware"
section.
Is the control knob set to the proper heat level? See
"Cooktop Controls" section.
Is the range level? Level the range. See the Installation
Instructions.
Oven will not operate
Is the electronic oven control set correctly? See
"Electronic Oven Control" section.
Has a delay start been set? See "Cook & Hold" section.
On some models, is the Control Lock set? See "Control
Lock" section.
Oven temperature too high or too low
Does the oven temperature calibration need adjustment?
See "Oven Temperature Control" section.
On some models, does the cooling fan run during Bake,
Broil or Clean?
It is normal for the fan to automatically run when the oven is
in use. This helps cool the electronic control.
Oven indicator lights flash
Do the oven indicator lights flash? See the "Electronic
Oven Control" section. If the indicator light(s) keeps flashing,
call for service. See "Assistance or Service" section.
15