Download Print this page
Maytag MER5752BAB - 30 Inch Electric Range Installation Manual
Maytag MER5752BAB - 30 Inch Electric Range Installation Manual

Maytag MER5752BAB - 30 Inch Electric Range Installation Manual

Electric 30-inch wide free-standing range
Hide thumbs Also See for MER5752BAB - 30 Inch Electric Range:

Advertisement

Available languages

Available languages

INSTALLER:
LEAVE
THESE INSTRUCTIONS
WITH THE APPLIANCE
ON MANUAL
IN
Electric 30-inch Wide
Free-standi
PLEASE
KEEP THIS MANUAL
e
FOR FUTURE
REFERENCE
THE MANUAL IS INTENDED
TO ASSIST IN THE INITIAL INSTALLATION
AND ADJUSTMENTS
OF THE RANGE.
Only qualified personnel should
install or service this range.
Read "Safety Instructions" in Use &
Care book before using range.
Improper
installation,
adjustment,
alteration,
service,
maintenance
or
use of range can result in serious
injury or property
damage,
CAUTION:
This range has been designed in
accordance with the requirements
of various safety
agencies and complies with the maximum allowable
wood cabinet temperatures
of 194°F. If this range is
installed with cabinets that have a lower working
temperature than 194°F, discoloration,
delamination
or melting may occur.
ENGLISH
0
PP. 1-6
ESPANOL
0
pag. 7-12
FRAN(_AIS
$
p. 13-18
CLEARANCE
DIMENSIONS
For complete information in regard to installation of
freestanding range, see figures 1 and 2 on page 2. For
SAFETY CONSIDERATIONS
do not install a range in
any combustible cabinetry which is not in accord with the
installation clearances shown in figure 1.
MOBILE HOMES
The installation of a range designed for mobile home
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part
3280 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24 HUD, Part 280) or,
when such standard is not applicable, the Standard for
Manufactured Home Installations 1982 (Manufactured
Home Sites, Communities and Set-Ups), ANSI
A225.1-1atest edition, or with local codes.
LOCATING
THE RANGE
Place range in a well lit area. Do not set range over
holes in the floor or other locations where it may be
subject to strong drafts. Any opening in the wall behind
the range and in the floor under the range should be
sealed. Make sure the flow of cooling/ventilation
air is
not obstructed below the range.
8101 P556-60
(06-03-00)

Advertisement

loading
Need help?

Need help?

Do you have a question about the MER5752BAB - 30 Inch Electric Range and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Maytag MER5752BAB - 30 Inch Electric Range

  • Page 1 INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE ON MANUAL Electric 30-inch Wide Free-standi PLEASE KEEP THIS MANUAL FOR FUTURE REFERENCE THE MANUAL IS INTENDED TO ASSIST IN THE INITIAL INSTALLATION AND ADJUSTMENTS OF THE RANGE. CLEARANCE DIMENSIONS For complete information in regard to installation of freestanding range, see figures 1 and 2 on page 2.
  • Page 2 INSTALLATION DRAWINGS "A" = 30 inches (76.2 cm) minimum clearance between the top of the cooking surface and the bottom of an unprotected wood or metal cabinet, or "A" = 24 inches (61 cm) minimum PLEASE KEEP FOR THE USE OFTHE when bottom of wood or metal cabinet is protected by not less than 1/4-inch (6.4 mm) thick flame-retardant millboard...
  • Page 3: Device Installation

    ANTI-TIP DEVICE INSTALLATION INSTRUCTIONS WARNING: A risk of range tip-over exists if the appliance STEP 2 - Anti-Tip Bracket Installation is not installed in accordance with the provided installation Options instructions. The proper use of this device minimizes the Wood Construction: risk of TIP-OVER tn using this device the consumer must Floor: Locate the center of the two holes identified...
  • Page 4 ANTI-TIP DEVICE INSTALLATION INSTRUCTIONS STEP 3 - Range Installation A. A free-standing range may be installed by one person. For SAFETY CONSIDERATIONS as well as optimum performance adjust the range so that it is level. This may be checked by placing a spirit level or a large pan B.
  • Page 5: Connecting The Range

    CONNECTING THE RANGE ELECTRIC SUPPLY Hence, 4-wire service MUST be provided for such installations. 3-wire service may be used when permitted The range must be installed in accordance with Local and by local code. USE COPPER OR ALUMINUM National Electric Code (NEC) ANSI/NFPA No. 70-latest CONDUCTORS.
  • Page 6 FIGURE 6 FIGURE 7 3-Wire Service Cord or Conduit Installation 4-Wire Service Cord or Conduit Installation 1. Insure that the copper ground strap IS CONNECTED (Mobile Homes Or As Required By Codes) between the middle post of the main terminal 1.
  • Page 7 INSTALADOR: DEJE ESTAS INSTRUCCIONES CON EL APARA TO MANUAL DE INSTA Estufa electrica individual de 30 pulgadas (76.2 cm) de ancho CONSERVE ESTE MANUAL PARA REFERENCIA FUTURA EL MANUAL TIENE LA FINALIDAD DE AYUDARLE EN LA INSTALACION Y AJUSTES INICIALES DE LA ESTUFA. DIMENSIONES DEL HUECO Para obtener la informaci6n completa relacionada con la...
  • Page 8 DIBUJOS DE INSTALACION "A" = 30 pulgadas (76.2 cm) espacio minimo entre la IMPORTANTE parte superior de la superficie de cocinar y la parte inferior de un gabinete sin proteccion de madera o SiRVASE CONSERVARLO PARA O UE LO I metal, o "A"...
  • Page 9 INSTRUCCIONES DE INSTALACIONDEL DISPOSITIVOESTABILIZADOR ADVERTENCIA: Existe la posibilidad de que la estufa se PASO 2 -Opciones para la instalacion ladee si no esta instalada de acuerdo alas instrucciones soporte estabilizador de instalaci6n que se proporcionan. El use correcto de Construcci6n de madera: este dispositivo reduce el riesgo de LADEO.
  • Page 10 INSTRUCCIONES DE INSTALACIONDEL DISPOSITIVOESTABILIZADOR PASO 3 - Instalacion de la estufa Por CONSIDERAClONES DE SEGURIDAD asi como A. Una sola persona puede instalar una estufa individual. para el funcionamiento optimo ajuste la estufa para que quede bien nivelada. Esto puede revisarse B.
  • Page 11 CONEXION DE LA ESTUFA SUMINISTRO ELI_CTRICO conexion a tierra mediante el conductor neutro. Por Io La estufa debe instalarse de acuerdo a los C6digos Electricos Locales y Nacionales (NEC) ANSt/NFPA No. tanto, DEBE proveerse un cord6n de servicio de 4 7O-Qltima edicion.
  • Page 12 FIGURA FIGURA Instalacion del conductor o los cordones Instalacion del conductor o los cordones servicio de 3 hilos servicio de 4 hilos (para casas moviles o como 1orequieran los codigos) 1. AsegQrese que la correa de tierra de cobre ESTI_ CONECTADA entre el poste central del bloque de 1.
  • Page 13 INSTALLATEUR VEUILLEZ LAISSER CES INSTRUCTIONS A VEC L'APPAREIL VEUILLEZ CONSERVER CE MANUEL POUR RI_FI_RENCE ULTI_RIEURE CE MANUEL EST DESTINE A FACILITER LA MISE EN SERVICE ET LE REGLAGE INITIAUX DE LA CUISINIERE. D#GAGEMENT N#CESSAIRE Pour tous renseignements concernant la mise en service d'une cuisiniere amovible, voir les figures 1 et 2, page La mise en service et le depannage 16.
  • Page 14 SCHI:!:MAS DE MONTAGE A = degagement minimum de 30 po (76,2 cm) entre la table de cuisson et le bas d'une armoire non protegee en bois ou en metal ; ou bien A = 24 po (61 cm) si le bas de CONSERVER A L USAGE DE I'armoire en bois ou en metal est protege par du carton...
  • Page 15 MISE EN PLACE DU SUPPORT DE STABILISATION ATTENTION : La cuisiniere risque de basculer si elle ETAPE 2 - Pose du support de stabilisation n'est pas mise en place conformement aux instructions Bois : fournies. Si le support est utilise correctement, il reduit le Plancher : Determiner le centre des deux trous risque que la cuisiniere ne BASCULE.
  • Page 16 MISE EN PLACE DU SUPPORT DE STABILISATION ETAPE 3 - Mise en place de la cuisiniere Pour des RAISONS DE SECURtTE et pour obtenir des Une cuisiniere amovible peut _tre mise en place par resultats optimums a la cuisson, regler la cuisiniere de une seule personne.
  • Page 17 RACCORDEMENT DE LA CUISINIERE ALIMENTATION ¢:LECTRIQUE derivation nouvellement installes (NEC 1996), les maisons mobiles, les vehicules de Ioisir ou dans toute Lors de la mise en service, la cuisiniere doit _tre installee region oQ les codes Iocaux interdisent la mise a la terre conformement aux normes NEC ANSI/NFPA n °...
  • Page 18: Installation

    FIGURE 6 FIGURE 7 Pose d'un cordon d'alimentation ou d'une Pose d'un cordon d'alimentation ou d'une gaine a 3 fils gaine a 4 fils (maisons mobiles ou si les codes I'exigent) 1. Verifier que,la barrette de mise a la terre en cuivre EST 1.