Pin Assignment; 12-Pin Multi-Connector (Dc-In/Trigger); Digital Output Connector For Camera Link - JAI CV-M 9CL Operation Manual

5. Pin Assignment

5.1. 12-pin Multi-connector (DC-IN/Trigger)

Type: HR10A-10R-12PB-01
(Hirose) male.
(Seen from rear of camera.)
9
1
2
8
10
3 11
12 7
4
6
5
Fig. 2. 12-pin connector.

5.2. Digital Output Connector for Camera Link

13
26
Fig. 3. Camera Link connector
The digital output signals follow the Camera Link standardized multiplexed signal output
interface. Camera Link base configuration is used for 3 x 8 bit RGB signal. The interface circuit is
build around the NS type DS90CR285MTD.
The following signals are found on the Digital Output Connector:
SerTC
SerTFG
CC1
CC2
X0 to X3
Xclk
In the Channel Link X0 to X3 multiplexed signals the following signals are encoded.
D0 – D9
LVAL
FVAL
DVAL
EEN
The polarity is positive and TRIG in negative as factory setting.
For Camera Link interface principle diagram please check Fig. 7.
CV-M9 CL
Pin no.
1
2 +12 V DC input
3
4 Iris video
5
6
7
8
9 XEEN out
10 Trigger in
11
12
Notes:
*1) See "7. Configuring the Camera" for more information.
SW301.1 Off for CL. ON for 12 p HR. (SW301.2 is for trig 75
Factory settings are shown in Bold Italic
Type: 26 pin MRD connector
1
3M 10226-1A10JL
14
RXD serial data to camera
TXD serial data to frame grabber
Trigger input
Factory use
Camera Link multiplexed data out
Camera Link clock. Used as pixel clock.
3 x 8 bit RGB video data out.
Line VALid. Video line data is valid. High for valid line.
Frame VALid. Video frame data is valid. High for valid frame.
Data VALid. Effective video pixel data is valid. High for valid data.
Exposure ENable. High during exposure.
Signal Remarks
GND
GND
Only Contin. and RCT mode. TR=0, TR=4
GND
RXD in
RXD in HR, or CL. SW301.1 off for CL *1)
TXD out
TXD in HR, or CL. SW301.1 off for CL *1)
GND
Low during exposure
TI=1 or in CL (TI=0). SW301.2 on for 75Ω
+12 V DC
GND
(SW301.1. Off for CL. On for HR)
(SW301.1. Off for CL. On for HR)
(TI=0 for CL. TI=1 for 12 pin HR)
- 4 -
Ω
).