Table of Contents
Advertisement
For analog signal
1. First perform an automatic adjustment. (P10)
2. Perform manual adjustment where necessary
(P11)
For digital signal
The monitor can generally be used without
adjustment. No manual adjustment should be
necessary.
Note：
- All adjustment will be saved even after turning the
power off
Resetting all adjustment values
All adjustment values can be returned to their
original ex-factory values in one command.
1. Turn off the monitor power.
2. Press the MENU button and the
button simultaneously, and while doing this press
the power button (i.e. turn the power on).
Continue to press the buttons until [ALL RESET]
appears on the screen. Reset is complete when
the displayed message disappears.
Note：
- While [ALL RESET] is displayed, the control
buttons are displayed.
- It is not possible to reset values when the
adjustment lock is in place. Remove the
adjustment lock before attempting to operate
control buttons.
SCREEN menu reset
Setting of items in the SCREEN Menu (CLOCK,
PHASE, H-POS, V-POS) can be returned to their
original ex-factory values.
1. Turn on the monitor power
2. Press the MENU button and the
simultaneously. When [RESET] appears on the
screen, the reset is complete.
Note：
- It is not possible to reset values when the
adjustment lock is in place. Remove the
adjustment lock before attempting to operate
control buttons.
Adjusting the screen display
/ MODE
button
Adjustment lock function
By disabling the control buttons (i.e. setting the lock)
any attempted changes to adjusted values will be
voided.
1. Turn off the monitor power.
2. While pressing the MENU button, press the
power button (i.e. turn power on).
Continue to press the buttons until
[ADJUSTMENT LOCKED] appears on the
screen.
The lock is set when the message is displayed.
Note：
- When the lock is in place, all buttons other than
the power button are disabled.
Adjustment lock release
1. Turn off the monitor power.
2. While pressing the MENU button, press the
power button (i.e. turn the power on).
Continue to press the buttons until
[ADJUSTMENT UNLOCKED] appears on the
screen.
The lock is released when the message is
displayed.
Adjusting the backlight
1. Without the OSD Menu being displayed, press
the
or the
button.
BACKLIGHT
2. Adjust by pressing the
button (lighter).
Note：
- On Screen display for adjustment disappears
several seconds after the last operation.
8
31
button (darker) or
Advertisement
Table of Contents
