Table of Contents
Advertisement
Adjusting the screen display
Automatic screen adjustment
Options in the SCREEN Menu can be adjusted
automatically (CLOCK, PHASE, H-POS, V-POS).
Note：
- When setting up this monitor for the first time or
after having changed an aspect of the current system,
perform an automatic screen adjustment before use.
Adjusting the screen automatically
1. Press the MENU button.
The SCREEN Menu will be displayed.
SCREEN
MANUAL
MANUAL
CLOCK
PHASE
H-POS
V-POS
INPUT-1
ANALOG
1280x1024 V:60Hz H:64.0kHz
2. Press the
button.
The screen will become dark and [ADJUSTING]
will be displayed. After a few seconds the
SCREEN Menu will return. (The automatic
adjustment is now complete.)
3. Press the MENU button 4 times to make the On
Screen Display (OSD) Menu disappear.
AUTO
127
16
127
32
(When using an analog signal)
Notes：
- In most cases automatic adjustment is sufficient.
- It may not be possible to achieve correct
adjustment with the first automatic adjustment. In
such a case, try repeating automatic adjustment 2
or 3 times.
- If necessary due to any of the following, manual
adjustments (P11) can be performed after the
automatic adjustment.
- When further fine adjustment is needed.
- When the computer's video input signals are
Composite Sync or Sync On Green. (Automatic
adjustments may not be possible.)
- When [OUT OF ADJUST] is displayed. (When
the screen displays an entirely dark image, the
automatic screen adjustment may be disabled.
When marking an automatic adjustment, be sure
to either use the Adjustment Pattern or try
displaying an image that makes the entire
screen very bright.)
- Automatic adjustment may not be achieved
correctly depending on what is displayed on the
screen – moving picture or the MS-DOS prompt
etc.
10
Advertisement
Table of Contents
