Service Configuration - Cisco ASR 5000 Series Administration Manual

Verifying and Saving Your Configuration
Enter the following command to display the IP address pool configuration:
The output from this command should look similar to the sample shown below. In this example, all IP pools were
configured in the isp1 context.
I
MPORTANT
features. Refer to the Command Line Interface Reference for more information.

Service Configuration

Verify that your service was created and configured properly by entering the following command:
<
The output is a concise listing of the service parameter settings similar to the sample displayed below. In this example, a
P-GW service called pgw is configured.
OL-22991-01
:
Many features can be configured on the system. There are show commands specifically for these
> < >
Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide ▄
Verifying the Configuration ▀