Rtp Ip Pool Configuration Verification - Cisco ASR 5000 Series Administration Manual

▀ RTP Pool Configuration
To ensure proper operation with CS network configuraiton, RTP IP pools should be configured within a
destination context.
Each address in the pool requires approximately 24 bytes of memory. Therefore, in order to conserve available
memory, the number of pools may need to be limited depending on the number of addresses to be configured
and the number of PSCs/PSC2s installed.
Setting different priorities on individual pools can cause addresses in some pools to be used more frequently.
For more information on commands/keywords that configure additional parameters and options, refer
command section in Context Configuration Mode Commands chapter of Command Line Interface Reference.

RTP IP Pool Configuration Verification

Step 1
Verify that your IPv4 address pool configured properly by entering the following command in Exec Mode:
The output from this command will look similar to the sample shown below. In this example all IP pools were
configured in the
▄ Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide
context.
HNB-GW Service Configuration Procedures
OL-22991-01