Iv. Installing The Navigation Software - Medion Navigation Unit Operating Instructions Manual

Note
Brief pressure on the On/Off button will be enough to switch the
device on or off, provided that your navigation system is connected to an
external source of electricity or is running in battery operation (standby
mode). The device will be reactivated by pressing the On/Off button
once (> ½ sec.).
You can adjust the period of operation to suit your needs using the
Settings button on the main screen of your device. Your device is deliv-
ered in a status in which it will not switch off independently.
To switch your navigation system completely off, push the main switch to
the OFF position.
No data will be lost as data is stored in the internal memory. The starting
process will only take slightly longer.
Your navigation system will use a low amount of electricity and the batteries will be dis-
charged, even when in standby mode.

IV. Installing the Navigation Software

The final installation of the navigation software will take place automatically from the in-
ternal memory, during the initial setting up, if your device has already been equipped with
the basic data of the navigation software at the factory. Follow the instructions on the
screen.
An optional memory card must always be inserted in the device while the navigation sys-
tem is being used.
It will be necessary to carry out a Reset to restart the navigation system if the memory card
has been removed (see page 26).
Please also read the chapter Navigation starting on page 28.
UK/ N. IRELAND HELPLINE 0871 37 61 020
REP. IRELAND HELPLINE 1-800-992508
- 16 -