Zoom H4next Operation Manual page 35

[Button operation during setting and <AUDIO I/F> menu]
Press.
<AUDIO I/F> MENU
EFFECT
MONITOR
PHANTOM
PLUG-IN
DISCONNECT
Select
and press.
[Selection of input source]
W h e n y o u p r e s s t h e I N P U T b u t t o n
corresponding to its input source, it lights
and is confirmed the selection.
While not using input, press the lighted
button and make light off, you make no
input condition.
* No input can send no signals to a computer and
operate no monitoring.
Use EFFECT (only on 44.1 kHz)
TUNER Use TUNER
Use MONITOR
Use PHANTOM power
Use PLUG-IN power
Disconnect
[You can use those
buttons during setting]
* Call [MENU] and make setting
* Adjust input / output level
Selecting input, input signals are sent to a
computer.
To monitor the input signals in H4n you
must run <MONITOR> setting on.
NOTE:
• You cannot change a sampling
rate while computer is recognizing
H4n as an audio interface.
• To connect as an Audio I/F, make
sure that a sampling rate (step 6)
matches the recording software
and playback file.
• You cannot use this setting during
recording and playback.
HINT:
Usage of AUDIO INTER FACE
• You can record input signals of
the H4n on the audio track of
DAW software, and listen to its
outcomes.
• You can also work those input
s i g n a l s i n t h e H 4 n b u i l t - i n
<EFFECT> function.
• The <EFFECT> can be used when
the sampling rate is 44.1 kHz.
• Making connection not necessary
for a specific driver.
• W h e n u s i n g d i f f e r e n t D A W
s o f t w a r e , p l e a s e r e a d t h e i r
guidebooks together.
034