Zoom H4next Operation Manual page 141

● Bass preamp effect types
SVT Simulation of Ampeg SVT sound.
BASSMAN Simulation of Fender Bassman 100 sound.
Simulation of Hartke HA3500 sound.
HARTKE
SUP-Bass Simulation of Marshall Super Bass sound.
SANSAMP Simulation of Sansamp Bass Driver DI sound.
ZOOM original tube preamplifier sound.
TUBE PRE
The above 6 effect types have the same parameters.
(1) CABINET 0 − 2
Adjusts the intensity of the speaker cabinet sound.
(2) GAIN 0 − 100
Adjusts the preamp gain (distortion depth).
(3) BASS -12 _ 12
Adjusts boost/cut in the low range.
(4) MIDDLE −12 _ 12
Adjusts boost/cut in the middle range.
(5) TREBLE −12 _ 12
Adjusts boost/cut in the high range.
Sets the mixing balance between the signal before
(6) BALANCE 0 − 100
input and after passing the module. Higher values
result in a higher ratio of post-module signal.
Adjusts the level of the signal after passing the
(7) LEVEL 1 − 100
PREAMP module.
(8) ZNR OFF,
Adjusts the sensitivity of the noise reduction circuit
(ZOOM Noise Reduction) 1 − 16 developed by ZOOM.
• Manufacturer names and product names mentioned in this table are trademarks or
registered trademarks of their respective owners. The names are used only to illustrate
sonic characteristics and do not indicate any affiliation with ZOOM CORPORATION.
● Mic preamp effect types
VO MPRE Preamp with characteristics optimized for vocals.
Preamp with characteristics optimized for recording an acoustic
AG MPRE
guitar.
FlatMPRE Preamp with flat characteristics.
The above 3 effect types have the same parameters.
Adjusts the parameter which keeps the level within
OFF,
(1) COMP a certain range by attenuating high-level signals
1 − 10
and boosting low-level signals.
OFF,
Adjusts the degree by which sibilants are attenu-
(2) DE-ESSER
1 − 10
ated.
Adjusts the frequency of a filter designed to at-
OFF,
(3) LOW CUT
tenuate low-frequency noise that is easily picked
1 − 10
up my a mic.
(4) BASS -12 − 12 Adjusts boost/cut in the low range.
(5) MIDDLE -12 − 12 Adjusts boost/cut in the middle range.
(6) TREBLE -12 − 12
Adjusts boost/cut in the high range.
Adjusts the level of the signal after passing the
(7) LEVEL 1 − 100
PREAMP module.
(8) ZNR OFF,
Adjusts the sensitivity of the noise reduction circuit
(ZOOM Noise Reduction) 1 − 16 developed by ZOOM.
140