Table of Contents
Advertisement
Periodic maintenance
1 . V-belt position adjusting bolt
2. Spacer
V-belt position
More than 1.5 mm
(0.06 in) above the
edge
From 1.5 mm (0.06 in)
above the edge to 0.5
mm (0.02 in) below
the edge
More than 0.5 mm
(0.02 in) below the
edge
Adjustment
Remove spacer
Not necessary (It is
correct.)
Add spacer
7. Tighten the V-belt position adjusting
bolts.
V-belt position adjusting bolt tightening
torque:
10 Nm (1.0 m·kgf, 7.2 ft·lb)
8. Install the V-belt over the primary sheave
assembly.
9. Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
1 . Secondary sliding sheave
2. Secondary fixed sheave
10. Install the V-belt between the secondary
sliding and fixed sheaves.
1 . V-belt
11. Install the drive guard, and then install the
left side cover and the shroud.
ESU12100
EWS00430
Drive chain housing
The engine, oil tank, brake disc, and cool-
ant hoses will be very hot after the engine
has been run. Avoid contact while they are
still hot with any part of your body or cloth-
ing during inspection or repair.
To check the drive chain housing oil level
1.
Place the snowmobile on a level surface.
60
Advertisement
Table of Contents
