Drive Chain Housing - Yamaha PZ50RTD Owner's Manual

1. Secondary sliding sheave
2. Secondary fixed sheave
5. Pull the V-belt up over the secondary
fixed sheave.
1. V-belt
6. Remove the V-belt from the secondary
sheave assembly and primary sheave
assembly.
7. Install the new V-belt over the primary
sheave assembly.
8. Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
Periodic maintenance and adjustment
1. Secondary sliding sheave
2. Secondary fixed sheave
9. Install the V-belt between the secondary
fixed sheave and the secondary sliding
sheave.
1. V-belt
10. Install the drive guard.
11. Install the left side cover (PZ50RT /
PZ50GT / PZ50MT), or install the left side
cover and the left upper cover, and then
close the shroud (PZ50VT / PZ50MP).
ESU12126

Drive chain housing

To check the drive chain housing oil
level
1. Place the snowmobile on a level surface
and apply the parking brake.
2. Remove the right side cover. (See page
60 for removal procedures.)
3. Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
75