Table of Contents
Advertisement
Control functions
1. Grip warmer adjustment switch
1 . Thumb warmer adjustment switch
To raise the temperature, press the respec-
tive switch to "HI". To lower the temperature,
press the switch to "LO".
ESU10690
Auxiliary DC jack
The auxiliary DC jack is located in the front
panel and can be used for accessories.
NOTE:
1 . Auxiliary DC jack cap
2. Auxiliary DC jack
NOTE:
After using the auxiliary DC jack, be sure to
remove the accessory power plug from the
jack and close the auxiliary DC jack cap.
ECS00120
CAUTION:
• Do not use accessories requiring more
than the maximum rated capacity for the
auxiliary DC jack. This may overload the
circuit and cause the fuse to blow. (See
page 71 for the specified amperage.)
• Do not use an automotive cigarette light-
er or other accessory with a plug that
gets hot because the jack can be dam-
aged.
Maximum rated capacity:
DC, 12 V, 2.5 A (30 W)
The auxiliary DC jack cannot be used if the
engine is not running.
ESU10560
Brake lever
The snowmobile is stopped by braking the en-
tire drive system.
Squeeze the brake lever towards the handle-
bar grip to stop the snowmobile.
To use the auxiliary DC jack
1.
Start the engine.
2.
Open the auxiliary DC jack cap, and then
insert the accessory power plug into the
jack.
18
Advertisement
Table of Contents
