Yamaha RX10RX Owner's Manual page 35

1 . Special wrench
2. Adjuster length
3. Rim
4. Scale range
4. Tighten the locknut while holding the con-
trol rod adjuster in place.
Locknut tightening torque:
35 Nm (3.5 m·kgf, 25 ft·lb)
ECS00320
CAUTION:
When using the special wrench, make
sure that it is situated at a right angle to
the control rod, and that it is tightly fitted
to the locknut or the control rod adjuster.
RX10RTR / RX10 MT / RX10MTA
1. Loosen the locknut while holding the con-
trol rod adjusting nut.
2. Turn the control rod adjusting nut in direc-
tion (a) to increase weight transfer or di-
rection (b) to decrease weight transfer.
Control functions
1 . Locknut
2. Control rod adjusting nut
EWS00170
Never adjust the control rods beyond the
maximum range indicated on the rods with
red paint.
1 . Red paint area
2. Adjustable range
3. Standard position
29