Yamaha RX10RX Owner's Manual page 34

Control functions
Rebound damping setting:
Minimum (soft):
22 click(s) in direction (a)*
Maximum (hard):
0 click(s) in direction (b)*
* With the adjustment dial in the stan-
dard position
RX10RTR
The compression damping force can be ad-
justed by turning the adjusting screw.
To increase the compression damping force,
turn the adjusting screw in direction (a). To
decrease the compression damping force,
turn the adjusting screw in direction (b).
1 . Compression damping force adjusting
screw
ECS00300
CAUTION:
• Do not continue to turn the adjusting
screw in direction (a) after it stops. The
shock absorber can be damaged and
damping force adjustments cannot be
made.
• Do not turn the adjusting screw in direc-
tion (b) more than 20 click(s). Even if the
adjusting screw is continually turned af-
ter 20 click(s), there will be no change in
the damping force.
• Be sure to stop the adjusting screw at a
position where there is a click.
ESU11040
Adjusting the control rods
The weight transfer can be adjusted by turn-
ing the control rod adjuster or adjusting nut.
RX10R / RX10LT
1. Loosen the locknut.
2. Turn the control rod adjuster in direction
(a) to increase weight transfer or direction
(b) to decrease weight transfer.
1 . Locknut
2. Control rod adjuster
EWS00180
Never adjust the control rod beyond the
range of the scale on the special wrench.
3. Check the control rod adjuster length us-
ing the scale on the special wrench in-
cluded in the owner's tool kit as shown.
Make sure that the rim of the control rod
body is within the range of the scale.
Compression damping setting:
Minimum (soft):
20 click(s) in direction (b)*
Standard:
11 click(s) in direction (b)*
Maximum (hard):
1 click(s) in direction (b)*
* With the adjusting screw fully turned
lightly in direction (a)
28