Table of Contents
Advertisement
5.2.3 LAN Interface
□
Was the PC7501 shut off and restarted after the IP address was set?
□
Is the interface selection switch on the rear panel of the emulator PC7501 set to "LAN"?
3.2.1 Interface Selection Switch (P.20)
□
Is the 10BASE-T cable connected correctly to both the emulator PC7501 and the hub?
4.2.3 Connecting by LAN Interface (P.29)
□
If the PC7501 and host machine are directly connected, are they connected by a 10BASE-T
cross cable?
□
If the PC7501 replies to the ping command in the DOS window, recheck the settings in the
Init dialog box of the emulator debugger M3T-PDxxF.
□
The interface setting of the emulator debugger M3T-PDxxF is specified by the Init dialog
box. Recheck the setting.
□
Is the emulator debugger M3T-PDxxF set for the LAN interface?
□
If the PC7501 and host machine are set to separate networks, execute the ping command
for the PC/EWS on the network to which the PC7501 is connected. If no reply is received,
check the network setting of the host machine.
□
If the PC7501 and host machine are set to separate networks, is a gateway set in the OS?
(192.168.1.254 in the figure below)
□
Does an IP address for a gateway registered with the PC7501 specify the gateway that the
PC7501 uses? (192.168.2.254 in the figure below)
Figure 5.1 Network configuration
38 / 46
Advertisement
Table of Contents
