Setting Time Data - Sony NXCAM NEX-EA50UH Operating Manual

Useful functions (Continued)
Tri-
GPS
angulating
indicators
status
Tri-
angulating
Tri-
angulating
• [GPS SETTING] is set to [ON] in the default
setting. Movies recorded during triangulation by
GPS will be recorded with location information.
If you do not want to record location
information, set [GPS SETTING] to [OFF].
• If the GPS indicator does not become a
triangulating status indicator even after several
minutes, the camcorder is having trouble with
receiving GPS signals. You may start recording
if you do not need to record location
information, or go to a location with access to
the open sky.
• The camcorder can hardly receive GPS signals
indoors or near tall buildings. Go to a location
with access to the open sky.
• Even if a triangulating status indicator is
displayed, the camcorder may not record the
GPS information continuously, depending on
the condition of GPS signal reception.

Setting time data

The camcorder records movies
accompanied by time data, such as time
code and user bit.
Presetting the time code
1 Press the MENU button, select
(TC/UB SET) t [TC PRESET]
with the SEL/PUSH EXEC dial, then
press the dial.
2 Select [PRESET] with the SEL/PUSH
EXEC dial, then press the dial.
60
GPS reception status
The camcorder is
receiving a GPS
signal, and can
acquire location
information.
The camcorder is
receiving a strong
GPS signal, and can
acquire location
information.
3 Select the first 2 digits with the SEL/
PUSH EXEC dial, then press the dial.
You can set the time code within the
following range.
When selecting [60i]
00:00:00:00 - 23:59:59:29
• When setting 24p, you can set the last
2 time code digits of the frames in
multiples of 4, between 0 and 23.
When selecting [50i]
00:00:00:00 - 23:59:59:24
4 Set other digits by repeating step 3.
5 Select [OK] with the SEL/PUSH EXEC
dial, then press the dial.
To reset the time code
You can reset the time code (00:00:00:00).
Select [RESET] in step 2 of "Presetting
the time code."
To reset the time code using the
Wireless Remote Commander
You can reset the time code (00:00:00:00)
also by pressing the TC RESET button on
the Wireless Remote Commander.
Presetting the user bit
1 Press the MENU button, select
(TC/UB SET) t [UB PRESET] with
the SEL/PUSH EXEC dial, then press
the dial.
2 Select [PRESET] with the SEL/PUSH
EXEC dial, then press the dial.
3 Select the first 2 digits with the SEL/
PUSH EXEC dial, then press the dial.
4 Set other digits by repeating step 3.
5 Select [OK] with the SEL/PUSH EXEC
dial, then press the dial.
To reset the user bit
You can reset the user bit (00 00 00 00).
Select [RESET] in step 2 of "Presetting
the user bit."