Sony NXCAM NEX-EA50UH Operating Manual page 50

Adjusting the color tone (Continued)
z Tips
• You can change the outdoor white balance
setting by setting an offset value. Press
(one push) button B while
selected and turn the SEL/PUSH EXEC dial E
to select an offset value from -7 (bluish) to 0
(normal, the default setting) to +7 (reddish).
You can also set the white balance offset value
from the menu ([WB OUTDOOR LEVEL],
p. 87).
• You can change the color temperature. Press the
(one push) button B when [MANU WB
TEMP] is set. Turn the SEL/PUSH EXEC dial
E until the desired temperature appears on the
LCD screen, then press the dial to set the
temperature ([WB TEMP SET], p. 87).
To save the adjusted white balance
value in memory A or B
1 Set the AUTO/MANUAL switch D to
MANUAL.
2 Press the WHT BAL button A.
3 Set the white balance memory switch to
A ( A) or B (
4 Capture a white subject, such as white
paper, full-screen in the same lighting
condition as the one in which the subject
is.
5 Press the
The adjusted value is stored in
B. The stored color temperature
appears for about 3 seconds.
b Notes
• When a white balance adjustment value has not
been obtained successfully,
turns to slow flashing. Adjust the subject
appropriately and set the shutter speed to auto or
around 1/60 (1/50), then try adjusting the white
balance again.
• It may take a long time to adjust the white
balance, depending on the recording conditions.
If you want to perform a different operation
before completing the adjustment, set the white
balance memory switch C to another position
to temporarily suspend white balance
adjustment.
50
(outdoor) is
B).
(one push) button B.
A or
To adjust the white balance
automatically
Press the WHT BAL button A.
b Notes
• When you set the AUTO/MANUAL switch D
to AUTO, iris, gain, ISO sensitivity, shutter
speed and white balance are adjusted
automatically. You cannot adjust manually.
A or
B