Recording Sound From An External Audio Device - Sony NXCAM NEX-EA50UH Operating Manual

Audio setup (Continued)
Recording sound from an
external audio device
To use an external audio device, or a
microphone other than the supplied
microphone, change the following settings.
1
Select the input source.
Set the INPUT 1/INPUT 2 switches
according to the devices connected to
the INPUT 1/INPUT 2 jacks.
Audio devices
External audio device
(mixer, etc.)
Dynamic microphones or
microphones with a built-
in battery
+48V powering
(
Phantom powering)
microphone
• If you connect a device that does not
support +48V phantom power, malfunction
may result from setting this switch to
MIC+48V. Check before connecting the
device.
• When there is no audio device connected to
an INPUT jack, set the INPUT switch of
that jack to LINE to prevent noise.
2
Set the input level of the
microphone.
• Set the input level to the sensitivity of
an XLR microphone you are using
with [INPUT1 TRIM]/[INPUT2
TRIM] in the menu (p. 93). [0dB] will
be appropriate for the supplied
microphone (ECM-XM1*).
* NEX-EA50UH/EA50EH/EA50H only
• You can set an input level between
-60 dBu (+12dB) and -30 dBu
(-18dB) by 6dB. The default setting is
-48 dBu (0dB).
52
3
Switch
position
LINE
MIC
MIC+48V
Select the channel you want to
record.
Using the CH1/CH2 switches, select the
source to be recorded on each channel.
When the CH1 switch is set to INT MIC
Input source and recorded
channel
INT MIC (L)
INT MIC (R)
INT MIC (mono)
INPUT 1
INT MIC (mono)
INPUT 2
When the CH1 switch is set to INPUT 1
Input source and recorded
channel
INPUT 1
INT MIC (mono)
INPUT 1
INPUT 1
INPUT 2
CH2
switch
setting
CH1
CH2
CH1
CH2
CH1
CH2
CH2
switch
setting
CH1
CH2
CH1
CH2
CH1
CH2