First Use Each Day (Tank And Boiler Empty) - Smeg CW–511 MDA User Manual

7.3 First use each day (tank and boiler empty)
Display shows
WARNING! If the appliance is connected to cold water, wait at least 30' before moving on to the
next phase to give the tank time to reach the correct washing temperature.
When the door is closed again, the last selected program will start
CW/CWH – 511 MDA
Door closed and master switch on ON:
Press
ON/OFF light and the two digits on the display light
up.
Close the door
The warewasher fills the tank automatically. At the
end of this phase, when the tank is full, P appears
on the display and program lights L5, L6 and L7are
lit.
Load the dishes or glasses and close the door.
Select the programme required by pressing one of
the three buttons; the LED of the selected program
flashes and the other two go out. The cycle starts
once the key has been held down for about 2".
While washing is in progress the display shows the
water temperature in the tank. During rinsing, it
shows the boiler temperature.
At the end of the program the program LED comes
on and "End" flashes on the display.
Unload the basket
22
Actions and what happens
and hold it down for 2‐3 seconds; the