Smeg CW–511 MDA User Manual page 24

TOTAL PUMP‐OUT AT THE END OF THE DAY
The warewasher is able to perform a pump‐out and self‐cleaning cycle with automatic switch‐off.
After a total pump‐out the filters should be cleaned as described in the relevant point.
Never switch the glasswasher off with water in the tank; always pump out first.
Models with water softener: if the set number of cycles is reached (see point 5.8. of
"Technical Manual"), the appliance automatically performs regeneration after pump‐out.
The entire process lasts about 15', after which the appliance switches off automatically.
Resin regeneration (for models with water softener)
Once the set number of wash cycles is reached (see point 5.8 of "Technical Manual") the LED above the
key flashes. Therefore, if during the working day resin regeneration is RECOMMENDED, follow the
procedure described below.
CW/CWH – 511 MDA
Press the pump‐out button
LED flashes and the pump‐out and automatic tank
cleaning phase starts.
When pump‐out is complete the appliance
switches to "OFF" status. (only 2 digits lit on the
display)
Press the key; the LED flashes and the
regeneration phase starts. It lasts about 10
minutes, during which time the LED keeps
flashing.
When the regeneration phase is complete, the
appliance switches to "OFF" status (only 2 digits
lit on the display).
To reuse the appliance, repeat procedure 7.3
24
for about 2", the