First Use Each Day (Tank And Boiler Empty) - Smeg HTY511DSUK Original Instructions Manual

9.2 First use each day (tank and boiler empty)

With the door/hood closed:
Press and hold it down.
The display shows the firmware version and update
installed, then the tank and boiler temperatures.
This is followed by FILL and the boiler water
temperature.
The boiler heating element symbol remains lit
until heating finishes. Once the water in the boiler
has been heated, filling of the tank starts.
Wait for P1 - END to appear and light L2 to change
from blue to green; if the water in the tank has to be
heated, comes on until the set temperature is
reached. The duration of this stage may vary
depending on the mains water temperature and on
the single-phase connection (if possible, depending
on the model).
Press the button quickly to display the tank (left)
and boiler (right) temperatures for a short time.
Load the dishes
Close the door/lower the hood and the cycle starts
1- Select the program required by pressing .
Only with Autostart OFF:
2- Confirm the program start by pressing and
holding it down for 1 second (light L2 changes from
green to blue).
Cycle in progress, the progress of the cycle is
displayed by vertical bars which illuminate in
sequence.
24