12 Screen-displayed anomalies (user) We recommend that you read all of the instructions contained in the manual attentively in order to become familiar with the most suitable conditions for the correct use of the dishwasher. TECHNICAL INSTRUCTIONS: Are intended for qualified personnel who will perform the installation, the setup, the testing and eventual assistance operations.
Page 3
SUBSTITUTION OF THE POWER CABLE MUST BE PERFORMED BY QUALIFIED PERSONNEL. THE DISHWASHER IS INTENDED EXCLUSIVELY FOR PROFESSIONAL USE AND MUST BE USED BY COMPETENT PERSONNEL. IT IS DESIGNED TO WASH DISHES (PLATES, CUPS, BOWLS, BAKING PANS, SILVERWARE) AND SIMILAR ITEMS FROM THE GASTRONOMY AND THE COLLECTIVE RESTAURANT INDUSTRIES.
Position the dishwasher in the desired position and remove the protective wrapping. Level the dishwasher (with the help of a level) on its four feet, regulating them in such a way so as to guarantee stability; any alternate solution must be approved by the manufacturer.
The user must provide for the installation, according to the norms in vigor, of a main electrical power switch and of a differential switch compatible with the machine’s characteristics. These switches must be installed near the dishwasher, be easily accessible after installation and guarantee complete disconnection from the electrical supply in category III overvoltage conditions.
Page 9
SETTINGS (only models CW400RSD - CW400R – CWC500R) MACHINE CONFIGURATION PARAMETERS ( Intended for technical personnel, not for the user ) RINSE CYCLE TIME, from 1 to 5 minutes, preset to 2 BOILER TEMPERATURE, from 60 to 95 °C, preset to 86 °C TANK TEMPERATURE, from 40 to 65 °C, preset to 55 °C...
Do not use detergents intended for hand washing. It is recommended to use products which were designed especially for this dishwasher. During the loading of the tanks be careful not to switch products as this could provoke dishwasher malfunction and damage.
The correct positioning of the filters, the rotation of the sprinklers, the absence of foreign objects within the dishwasher. button. The led indicator to the right of the button led indicator will begin to flash. Once filling has been completed it becomes a steady green.
Page 12
Total drainage at the end of the day The dishwasher is capable of performing an auto-clean cycle at the end of the day. At the end of the working day press the drain button close the hood.
10.3 Prolonged disuse If the use of the dishwasher is not foreseen for a relatively long period of time it is necessary to drain the detergent and rinse-aid dispenser in order to avoid crystallization and pump damage: Remove the suction tubes from the detergent and rinse-aid containers and emerge them in a container filled with clean water.
Page 14
If the problem persists contact assistance. Verify that the dishwasher’s tube and drain are not blocked and that the drain is not in too high of a position; see the connection diagram.
Page 15
12 SCREEN DISPLAYED ANOMALIES (USER) After having turned the machine off and on again, if the problem persists communicate the type of error displayed on the screen to technical assistance: Boiler sensor malfunction Tank sensor malfunction Water loading timeout ( the water loading duration has exceeded the time set in P9 ) Draining anomaly.