Table of Contents
Advertisement
9.2 First use each day (tank and boiler empty)
With the door/hood closed:
Press
and hold it down.
The display shows the firmware version and
update installed, then the tank and boiler
temperatures.
This is followed by FILL and the boiler water
temperature.
The boiler heating element symbol
remains
lit until heating finishes. Once the water in the
boiler has been heated, filling of the tank starts.
Wait for P1 - END to appear and light L2 to change
from blue to green; if the water in the tank has to
be heated,
comes on until the set
temperature is reached. The duration of this stage
may vary depending on the mains water
temperature and on the single-phase connection
(if possible, depending on the model).
Press the
button quickly to display the tank
(left) and boiler (right) temperatures for a short
time.
Load the dishes.
Close the door / hood (depending on the model).
N.B.: if the autostart function is set as ON and the
dishwasher is ready, the cycle starts when the
door is closed/the hood is lowered
1- Select the program required by pressing
.
Only with Autostart OFF:
2- Confirm the program start by pressing
and
holding it down for 1 second (light L2 changes from
green to blue).
Cycle in progress, the progress of the cycle is
displayed by vertical bars which illuminate in
sequence.
27
Advertisement
Table of Contents
