The Navigator; Presetting The Navigator - VDO Cyclecomputing MC1.0 Instruction Manual

2.7 The NAVIGATOR

GB
The NAVIGATOR is a second, individual trip distance counter that can be:
MC
• manually reset to zero
1.0
• preset to a certain value, the trip distance is then counted from this value.
The NAVIGATOR is very helpful following road book instructions or tour suggestions of bike magazines.
For example, your road book tour wants you "to go straight for a mile and then make a right turn, then go on for half a mile and make a sharp left turn".
These instructions can be precisely followed by using the NAVIGATOR. Once you have arrived at the first intersection after the first mile, you reset the
NAVIGATOR to zero and and follow the next leg for half of a mile. At the second intersection you reset to zero again and follow the next instruction of your
road book.
The NAVIGATOR can be preset and proceed from this individual value. For example, you are unable to start your tour at the point 0 km/m, but at 5.3 km.
This value can be preset / entered into the NAVIGATOR. The NAVIGATOR will then count on from 5.3 km. Should you have made a wrong turn, return to
that spot and enter your leg distance anew, continue to follow your roadbook instructions

2.7.1 Presetting the NAVIGATOR

Step 1: MODE 2 calls NAVIGATOR into display
Step 2: Press MODE 1 for 3 sec. The lower part of the display alternetely shows "ENTER NAVIGATOR" and "000.00" with the last digit "0" flashing.
Step 3: By pressing MODE 2 you increase the flashing number, by pressing MODE 1 you jump to the next number 000.00, etc.
Step 4: Once the NAVIGATOR is preset, exit setup mode by pressing MODE 1 for 3 sec. The display shows NAVIGATOR and the preset value.
Your VDO MC 1.0 will be counting on from this preset value.
12