Setting Up / Entering Your Home Or Basis Altitude; Re-Calibrating The Altimeter To Absorb Changes In Barometric Pressure - VDO Cyclecomputing MC1.0 Instruction Manual

Table of Contents

6.1.2. Setting up / entering your home or basis altitude

Step 1: By pressing ALTI call TRIP ALTI in the display. Push MODE1 for 3 sec ENTER HOME ALTI TUDE and its previous value will be displayed.

1.0

Step 2: By pressing MODE2 the previous value is increased. Hold down the button to quickly scroll. By pressing MODE1 the previous value is decreased.

Hold down the button to quickly scroll. Display capacity from -300 to +6000 meters / -984 to +19685 feet.

Step 3: Once you have entered your home altitude, terminate set-up by pressing ALTI for 3 sec. TRIP ALTI information will be back in display. Depending

on the home altitude entered the actual altitude may read out differently.

6.1.3. Re-calibrating the altimeter to absorb changes in barometric pressure

Changes in barometric pressure make your VDO MC 1.0 change the readout of the current / actual altitude. This new readout may differ from the value you

have determined for your home altitude (= same location but changed barometric pressure). So before you go out for a ride, readjust the actual displayed altitude

to your home altitude. The easy-to-use re-calibration feature allocates the changes in barometric pressure to the home altitude you have entered.

Step 1: Get TRIP ALTI in display

Step 2: Press Mode 1 for 3 sec will bring "ENTER HOME ALTITUDE in Display

Step 3: Press Mode1+Mode2-button for 3 sec.

Automatic recalibration of actual air pressure to your home altitude setting will be done, after that the display will show TRIP ALTI again.

Table of Contents